SAG-A
Stand Alone Gamma Alarm system
This device is adapted for the measurement of Ambient dose equivalent rate, especially for nuclear plant workers. This beacon was conceived to be as resistant as possible. Its cylindrical shape and its bumpers design allow for maximum shock absorptions and drops up to 1.6 m. The beacon polycarbonate body resists repeated hammer blows. The protection factor IP 65 means that the SAG-A is fully protected against dust and splashing water from all directions. The SAG-A beacon is designed to float temporarily.
SAG-A support
Detection Characteristics
Reference value: Ambient dose equivalent rate H*(10)
Reference source: Cs 137
Effective range: 0.010mSv/h to 99.9mSv/h
Display range: 0.001 mSv/h to 99.9 mSv/h
Response time: < 2s on all the measurement range
Energy range: from 50 keV to 1.5 MeV
Alarm Characteristics
PCT/PRC overdue: "PCT/PRC" display and malfunction alarm
Various indications: low battery, charge, remote measurement display, LED indicates an electrical outlet connection
Probe saturation: "SAT" display
Probe malfunction: "SENSOR FAULT" display
Visual alarm: 3 warning light towers (green, yellow and red)
Audible alarm: buzzer > 85dBA at 30cm
Threshold: 1.6mSv/h factory pre-set and configurable with a key
Electrical Characteristics
Battery life : up to 40 days
Battery charger: 12V
Charging time: 1 day (usable during the charge)
Connectivity
Relays: 3 dry relay contact outputs (On, Failure, Alarm):
- 40W with 48VDC
- 60VA with 24VAC max – on resistive charge
Network connectivity: 2 x 2 RS 485 Modbus/Jbus (EDF beacon supervision compatible)
Mechanical and Environmental Characteristics
IP code: IP 65
Operating temperature: -20°C to +50°C
Sensitivity to temperature: < 0.1%/°C on all the range
Housing materials: Polycarbonate and Polyurethane
Weight: 2.9 kg (with Dolphy Evolution)
Dimensions: 460 x 160 x 160 mm
Regulatory Compliance
Compliance: IEC 60532-3 : 2010
Datasheet:
English 
Français